Supplementary Sheet to Installations Instructions Installation Kit for Video Module and TV Amplifier for TV Function in Conjunction with Installation Kit for On-Board Monitor and Navigation BMW 5 series (E39), order No.: 01 29 0 007 858

EBA – 01 29 0 009 337
BMW Installation Instructions

Installation Kit Video Module and TV Amplifier for TV Function together with Installation Kit for On-Board Monitor and Navigation BMW 5 Series (E39)

Supplementary Sheet to Installations Instructions Installation Kit for Video Module and TV Amplifier for TV Function in Conjunction with Installation Kit for On-Board Monitor and Navigation BMW 5 series (E39), order No.: 01 29 0 007 858

Important Information!

The following points must be observed:

Section 2.3 Page 2-23, Encoding

The text for Section 2.3 Encoding is no longer applicable and is being replaced by:

Notes

Refer to general information as well as safety notes in Section 1.

This system requires encoding to ensure:

  • that the retrofit system is operable to its full extent and

and, if necessary, other vehicle components must be encoded and stored in the central encoding code of the IKE. This encoding procedure is conducted automatically with the current coding program in the path “Retrofit’1, be observed.

Procedure:

  • Connect DIS/MoDiC III to vehicle
  • Ignition “ON”
  • Selection “Encoding ZCS”
  • Confirm date entry with “Y” (MoDiC only)
  • Series: “E39”
  • Path: “2 Retrofit”
  • System: “7 Navigation”
  • Prompt: “Is a video module fitted?”

-Confirm: “Yes”

^ “Navigation CD-ROM Operating Software” will be required to load the operating system.

Caution! Do not yet insert the “Operating Software” CD ROM in the CD drive at this point! Only insert the “Operating Software” CD ROM in the drive when instructed to do so in the information provided on the on-board monitor.

Voice encoding is also carried out with this “Operating Software” CD ROM.-<

  • Start automatic encoding (confirm with “Y”)
  • Follow information provided on on-board monitor.
  • Print out new label with modified encoding code and affix on vehicle in luggage compartment on right in area of battery.

-After the message “Encoding completed” on the DIS/MoDiC monitor, switch ignition “OFF”, wait at least 10 seconds before switching ignition “ON” again.

  • Print out fault code memory.
  • Insert “Road Map” CD ROM in navigation computer.
  • Carry out function check.

The DSP amplifier must be additionally recoded on vehicles with DSP amplifier.<

 

Procedure:

  • Connect DIS/MoDiC III to vehicle
  • Switch ignition “ON”
  • Select “Encoding ZCS”
  • Confirm date entry with “Y” (MoDiC only)
  • Series: “E39”
  • Path: “1 Recoding”
  • System: “82 DSP”
  • Start automatic encoding (confirm with “Y”)

-After the message “Encoding completed” on the DIS/MoDiC monitor, switch ignition “OFF”, wait at least 10 seconds before switching ignition “ON” again.

  • Print out fault code memory.
  • Carry out function check.

Voice encoding

Voice encoding can again be carried out with the “Navigation CD ROM Operating Software”.

banner