X
    Categories: Fog lights

Fog Lamp Installation Kit BMW 6 Series E24

EBA – 01 29 9 760 530
BMW Installation Instructions

All work is shown on a LHD model. On RHD models some operations will be symmetrically opposite.


Disconnect negative wire from battery. Secure earth wire from additional loom to front left earthing point.

Expose front left terminal strip above battery. Connect additional loom to matching colours on terminal strip. Route additional loom along existing loom to fog lamp location and secure it.

630 … 633 i:

Foglamp fitting sequence on bumper

1 = Fog lamp bracket
2 = Bolt
3 = Washer
4 = Bumper
5 = Spring washer
6 = Nut

635:

Place reinforcement plate inside and attach bracket with M 6 x 20 screws.

Note: Welded M 8 nut on bracket goes towards vehicle centre.

Install fog lamp on bracket

1 = M 8 x 20 bolt

2 = Lock washer

3 = Fog lamp

Fitting sequence:

1 = Reinforcement plate
2 = Bracket
3 = Bumper
4 = Spoiler
5 = M 8 bolt
6 = Fog lamp

630 … 635:

Install reflector.

Insert 12 V 55 W bulb. Connect wire (1) from bulb to terminal on reflector.

Pull wire through and insert rubber grommet.

Connect wire to reflector.

1 = Live wire
2 = Earth wire

Note: If there is an earth wire in the additional wiring, the earth wire in the fog lamp housing is to be removed.

Remove screws and take trim off.

Lift out trim frame of Check-Control.

Remove printed circuit.

Leave wiring attached.

Remove lighting switch. Leave wiring attached. Pull switch lighting off from the rear.

Fitting note: Insert switch in retainer.

Pull knob off left fresh air switch and lift cover out.

Remove fog lamp switch. Leave wiring attached.

Pull switch lighting off from the rear.

Fitting note: Insert switch in retainer.

Remove screws for instrument carrier on left.

Remove screws for instrument carrier on right.

Loosen bolts in mounting for steering wheel adjustment.

Lift instrument carrier out slightly and detach speedo cable.

Press upper part of trim with steering column down so far that the instrument carrier can be taken out at an angle.

Pull central connector off and take instrument carrier off.

Take existing wire with holder for fog lamp warning light out of clip. Insert bulb in holder.

Pull adhesive tape on instrument carrier off. Insert holder with bulb into instrument carrier. Install instrument carrier.

Pull wiring off fog lamp switch.

Release tied-back wiring.

Attach wiring to new fog lamp switch as marked.

1 = grey/violet
2 = grey/red
3 = grey

Install fog lamp switch.

Insert fog lamp relay (1) and, if applicable, fuses No. 15 and 16 (8 Amp.)

Install all parts removed.

Functional check: Connect battery earth wire. Switch on ignition and headlights. Switch fog lamp switch to stage 1. The fog lamps and the green warning light in the instrument cluster must now be on. Move fog lamp switch to stage 2. The fog lamps, the rear fog lamp and the green and yellow warning lights in the instrumennt cluster should now be on. The fog lamps must not be on when the headlight high beams are on and the fog lamp switch is at stage 1. The green warning light may be on. When headlights are switched to high beam and the fog lamp switch is at stage 2 the fog lamps must go out. The rear fog lamp and the green and the yellow warning lights in the instrument cluster must remain on.

Check tyre pressures and rectify if necessary. Place vehicle on a level surface and load with 70 kg (1 person) in centre of back seat. Adjust fog lamps with an optical applicance in accordance with the instructions from the manufacturer.

This article was last modified on August 20, 2018 8:31 am

eba :
Disqus Comments Loading...

This website uses cookies.