Hands-Free Facility for Mobile Telephone BMW 3 Series E36/5 (Compact)

EBA – 01 29 9 789 227

BMW Installation Instructions

Intended for use in BMW dealer organisation only. Installation time is approx. 1 hour, though this may vary depending on the condition of the vehicle and its fittings.

Specialised knowledge is required.

Important!

This hands-free facility is intended to be connected only to the BMW D-Netz Telephone. BMW cannot guarantee its function when used in conjunction with other mobile telephones.

Note

Installation is described for left-hand drive models.

Certain work steps must be

carried out in mirror-image fashion for right-hand drive models.

Tools and materials required

1/4″ Ratchet
Phillips screwdriver
Socket wrench, 10 mm NF

Contents

Chapter

  1. Necessary Preliminary Work on Vehicle
  2. Overview of Wiring Harness Connections
  3. Installing in Vehicle

1. Necessary Preliminary Work on Vehicle

Remove glove compartment
Remove lower left-hand instrument cluster trim panel
Remove front footwell speaker panels Remove centre console

2. Overview of Wiring Harness Connections

F 36 84 021 R

A= Hands-free facility connection cable

A1= Connect 4-pin, black connector for hands­ free facility (cable colours brown and white) to 4-pin, black connector on telephone connecting cable

A2= Connect 4-pin, black connector for microphone connection (cable colours brown and white) to microphone in bottom of storage tray

A3+A4= Connecting cable for double coil speaker (cable colours green and yellow) in left and right-hand footwells

3. Installing in Vehicle

F 36 84 041 R

As shown in the illustration, lay the connecting cable (1) from the centre console to the speakers (cable colours green and yellow) (2) and to the microphone (cable colours brown and white) (3). Connect the 4-pin black connector (cable colours brown and white) to the telephone connecting cable branch near the centre console.

F 36 84 042 R

Important!

When installing the microphone, the arrow on the microphone must point upwards.

Connect the microphone (1) to the coded, 4-pin connector of the hands-free facility (cable colours brown and white) for the microphone and clip into the right-hand opening of the switch carrier (2).

F 36 84 011 R

Replace the radio speaker (1) with the double coil speaker of the hands-free facility (2). Ensure that the double coil speaker is correctly positioned.


banner